Setting up the Kerlink iFemtocell Evolution

The Kerlink iFemtocell Evolution receives radio transmissions from the Microshare IoT devices in and around your building and uses an integrated cellular/mobile connection to send data securely to the Microshare Smart Network.
Please make sure your selected physical install location will allow for a good cellular signal and is central to the IoT devices you will use in your facility. Contact Microshare if you have any doubts on the best place to install the gateway. Bad placement will result in poor performance of the overall system.
Microshare delivers Kerlink iFemtocell Evolution pre-configured with a 4G SIM card already activated. All you need to do to have your LoRaWAN network up and running is to :
1. Connect the antenna
2. Plug into a mains power source
3. Wait 1-2 minutes for the connection to be established

Connect antenna

1.1
Screw the antenna to the gold connector on the right-hand side of the iFemtocell Evolution

Re-Assembly

1.2
Screw the antenna to the gold connector on the right-hand side of the iFemtocell

Power adapter

2.1
Plug the power adapter into the iFemtocell Evolution

2.2

Plug the power adapter to an electricity outlet

Connection

3.1
After 1-2 minutes, the two LEDs on the front will turn solid green, your LoRaWAN gateway is up and running and your sensors can be deployed in your building.
You’re all done! Please send an email to support@microshare.io to indicate the Gateway is up and running so we can confirm at our end.
Please note that if you have the legacy Kerlink iFemtocell with a separate USB cellular connection, the  instructions are available here.